A hot water system that has stopped working leaves you with cold showers, half-done dishes and a household out of routine. Before you assume you need a whole new system, it helps to understand what commonly goes wrong, what you can safely check, and which faults need a licensed plumber, electrician or gas fitter. Whether you have an electric storage tank, a gas unit, continuous flow, or a heat pump, working through the likely causes in order saves Wollongong homeowners time and money.
A hot water system that is not working usually has one of a handful of causes. On electric systems, look at the power supply, the off-peak circuit, a failed element or thermostat, or heavy sediment. On gas systems, look at the pilot light, ignition, gas supply or valve. A leaking tank, a stuck relief valve, or simply an ageing system are also common. You can safely check switches, the pilot light and for leaks. Electrical, gas and valve faults must be left to a licensed professional for safety.
Knowing your system type points you to the right checks. Electric storage tanks heat water with an element and store it. Gas storage tanks use a burner and pilot. Continuous flow units heat on demand and show fault codes. Heat pump systems draw warmth from the air and suit the Illawarra’s mild climate. Each fails in different ways, so identifying yours first avoids wasted effort.
The simplest cause is a power issue. A tripped breaker or a switched-off off-peak hot water switch stops the tank heating. Confirm the switch is on. If it trips again, call an electrician.
These are the most common internal faults on electric tanks. If the power is on and the water is cold, one of these has likely failed. Replacement is an electrical repair best left to a technician.
Heavy sediment reduces capacity and efficiency, so the system seems to underperform. Our guide on sediment in a hot water heater covers the signs and the fix.
A pilot that will not stay lit is a frequent gas fault, often caused by a faulty thermocouple or a draught. Some units allow a homeowner to relight following the printed instructions, but a pilot that keeps going out needs a gas fitter.
If other gas appliances also fail, the issue is your supply. If only the hot water is affected, the gas valve or burner may be at fault, which is licensed work.
Continuous flow controllers display error codes that pinpoint the problem. They help diagnosis, but most repairs require a qualified technician.
Water pooling under the tank suggests a leak, which usually means replacement. Rusty water can indicate internal corrosion. A relief valve constantly releasing water, or no hot water alongside a hissing or burning smell, calls for immediate professional attention. If you notice a gas smell, leave the area and contact your gas provider and a licensed gas fitter straight away.
You can confirm switches and breakers are on, check whether the gas pilot or fault light is lit, see whether other gas appliances work, and look for water under the tank. You can also reset a tripped breaker once.
You should not open electrical covers, touch the gas valve or burner, operate the temperature pressure relief valve beyond a gentle manufacturer-recommended check, or attempt internal repairs. Those are tasks for a licensed plumber, electrician or gas fitter.
For a system under ten years old, most faults are worth repairing. A licensed technician can replace an element, thermostat, thermocouple or valve and restore the system at a fraction of replacement cost. Booking a professional for hot water repairs ensures the work is done safely and correctly. Many Wollongong households value same day attention when a system fails.
If your system is over ten to twelve years old, has failed repeatedly, or is leaking, replacement is usually the better investment. Coastal corrosion can shorten the life of older units, so it is worth factoring in. You can compare replacement options, browse available hot water systems, and review hot water system prices before you decide.
A hot water system that has stopped working usually has a clear and fixable cause. Safe checks rule out the simple issues, while anything electrical, gas related or leaking needs a licensed hand. Wollongong Hot Water Systems can diagnose, repair or replace your system and get hot water back fast. Contact the team for a quote or to book a repair.
